1.

Sectional doors from the item 80 252 can also be shown in the open state. The plastic part can be shortened as desired ...

2.

... and with plastic glue attached to the back of the wall part.

3.

An interesting variant - workshop with various gates.

4.

A model facade with opened windows and doors are always an eye-catcher. You need two identical windows.

5.

Remove from one of the two windows the rungs of the desired wing and file the opening a little bit larger.

6.

Cut the matching window wing from the other window. File the window wing with a file narrower.

7.

Glue the window first into the wall - without using the second wing. Glue the foil, but please avoid the open window side. Fit also foil at the openly presented wing and fix it with glue. Only then can the wing be attached.

8.

Attach always the window foil first, when you want to show an open door.
Then carefully remove the adhesive strips from the door.

9.

To fix the open door wing is easy.

10.

When the door is open, you can also look inside. Therefore a piece of floor should be indicated. This can be easily cut from a plastic part from the box. Please ensure that this part is glued exactly at right angles to the wall.

11.

With the steps from the item 80 250, which also contains the door, everything is complete.

12.

The craftwork has been successful so far. Everyone would be disappointed, if something was damaged by little carelessness. The movable door wings should be protected after installation with removable adhesive tape. Which protects against uncontrolled opening of the doors. When removing the tape, secure the gate with your fingers.